OVERVIEW
Replace a damaged original 12-volt outlet socket
1K0-919-309 is the Genuine VW/Audi metal accessory power outlet socket used in the specified original Volkswagen outlet locations. Its cylindrical contact housing and molded electrical connector base provide the connection between the vehicle wiring and a compatible 12-volt accessory plug.
Wear, corrosion or heat damage can prevent an accessory plug from making consistent contact. Replacing the correct socket restores the original contact assembly when the fault has been traced to the outlet itself.
Technical details
- Complete factory number: 1K0-919-309.
- Factory specification: factory 12-volt accessory outlet socket, complete number 1K0-919-309.
- Design: metal cylindrical socket with molded black connector base, as pictured.
- Quantity supplied: one individual outlet socket.
This listing supplies the individual socket shown. Trim bezel, illumination ring, protective cap, wiring, fuse, heating insert and USB adapter are separate. Match the original connector and mounting sleeve before ordering.
Common reasons to replace
- Accessory plugs lose contact because the socket contacts are worn or damaged.
- The socket has corrosion following moisture entry.
- Heat damage has distorted the original connector base or socket.
- The metal housing is damaged during interior trim service.
Check the circuit fuse, supply voltage, ground and accessory plug before replacing the socket. A wiring fault, blown fuse or defective charger can produce the same symptom as a failed outlet. Repair any overheated connector or damaged wiring as required.
Vehicle fitment
Fitment depends on the original outlet location and equipment. The listed vehicles must have the matching 1K0-919-309 socket; the entry does not identify every power outlet fitted to each vehicle.
| Vehicle | Model years | Engine | Configuration | Application restrictions |
|---|---|---|---|---|
| Volkswagen Tiguan | 2009–2017 | 2.0L turbocharged gasoline inline-four | First-generation SUV; FWD or 4MOTION | Original 1K0-919-309 socket position only; match connector, retaining sleeve and outlet location. |
| Volkswagen Tiguan | 2018–2024 | 2.0L turbocharged gasoline inline-four | Long-wheelbase SUV; FWD or 4MOTION | Original 1K0-919-309 socket position only; excludes USB modules and 115V inverter outlets. |
| Volkswagen Jetta | 2013 | 2.0L or 2.5L gasoline; 2.0L TDI; 2.0L turbocharged gasoline GLI; 1.4L Hybrid | Sedan; original rear accessory outlet equipment | Rear outlet with matching original part number and connector; equipment dependent. |
Installation guidance
Disconnect the circuit according to the vehicle repair procedure. Remove the socket using the specified extraction method so the retaining sleeve and surrounding trim are not damaged. Inspect the electrical connector before connecting the replacement.
Seat the outlet and retaining components correctly, restore power and verify operation with a suitable accessory. Observe the vehicle's stated outlet current limit and fuse specification.
Ordering information
One Genuine VW/Audi socket as pictured. Confirm the original number, connector and mounting arrangement; trim pieces and electrical accessories are separate.