OVERVIEW
Genuine VW/Audi convertible roof hydraulic line securing clip set
8H0-898-802-A is the original securing-clip set for the assigned hydraulic-line connection in the convertible-roof system. The confirmed applications below cover the matching Eos roof-hydraulic arrangement.
One set contains two securing clips, as shown in the product photo. The clips are supplied separately from the hydraulic lines, cylinders, pump, seals and hydraulic fluid.
Technical details and supplied quantity
- Manufacturer part number: 8H0-898-802-A; compact reference 8H0898802A.
- Brand: Genuine VW/Audi.
- Component: convertible-roof hydraulic-line securing clips.
- Configuration: original clip profile for the assigned line connection.
- Quantity: one set of two clips per purchase.
The required number of sets depends on the connections included in the repair. A complete roof system can use several sets. Match the original connection and clip profile rather than treating the set as a universal retainer for hydraulic components.
Common reasons to replace
- A securing clip is missing after line or cylinder service.
- The retaining profile is damaged during removal.
- The clip is distorted and no longer engages the prescribed connection correctly.
- The factory repair procedure calls for renewal of the affected securing clips.
The clips provide mechanical retention at the assigned connection. A leaking line, damaged seal or defective roof component requires its own repair. Replacing clips alone does not correct a hydraulic leak or a roof-operating fault caused elsewhere in the system.
Vehicle fitment
These entries require the original Eos roof-hydraulic line connection assigned 8H0898802A. Confirm the specific connection and required set quantity before ordering.
| Vehicle | Model years | Engine | Configuration | Application restrictions |
|---|---|---|---|---|
| Volkswagen Eos | 2007–2015 | 2.0L turbocharged FSI/TSI gasoline I4 | 1F Convertible; front-wheel drive; original retractable-roof hydraulic arrangement; Original factory manual or DSG as offered; roof hydraulic-line connection determines fitment | Only the original convertible-roof hydraulic-line securing location assigned 8H0898802A. One two-clip set supplied; match existing clip profile and exact line connection. Multiple sets may be required for a complete system repair. Hydraulic lines, cylinders, pump, seals and hydraulic fluid are separate. |
| Volkswagen Eos | 2007–2008 | 3.2L gasoline VR6 | 1F Convertible; front-wheel drive; original retractable-roof hydraulic arrangement; Original factory manual or DSG as offered; roof hydraulic-line connection determines fitment | Only the original convertible-roof hydraulic-line securing location assigned 8H0898802A. One two-clip set supplied; match existing clip profile and exact line connection. Multiple sets may be required for a complete system repair. Hydraulic lines, cylinders, pump, seals and hydraulic fluid are separate. |
Installation and service guidance
Follow the factory convertible-roof hydraulic service procedure. Position and support the roof as prescribed and perform the specified pressure-management steps before disturbing any hydraulic connection. Keep the connection clean throughout the repair.
Inspect the mating line, receiving component and separately specified seals before installing the clips. Use the exact original retention arrangement and verify that each clip engages its assigned position fully. Do not force an incompatible retainer into a connection.
Complete the applicable fluid, leak and operating checks after reassembly. Confirm the repaired connection and roof movement according to the factory procedure before returning the vehicle to service.