OVERVIEW
Genuine VW/Audi lower door molding retaining screw
N-014-122-16 is an original Audi fastener used at the assigned front-door lower molding attachment. It provides the threaded fastening point that holds the molding at its factory mounting location. Correct hardware helps restore a secure attachment when the molding is removed for service or when the original screw is missing or damaged.
The confirmed application below identifies the lower molding attachment, rather than the window belt molding, window regulator or interior door trim. Those assemblies can use different clips and fasteners even within the same vehicle. Select this screw by its complete part number and original mounting position.
Technical details and supplied quantity
- Manufacturer part number: N-014-122-16; compact reference N01412216.
- Brand: Genuine VW/Audi.
- Component: threaded retaining screw for the specified lower door molding fastening point.
- Verified attachment: front-door lower molding on the listed Audi A6 configuration.
- Quantity: one screw per purchase. Door moldings, clips, receiving hardware and other fasteners are supplied separately.
The screw must match the original receiving attachment. Similar-looking trim screws can differ in thread, head profile and engagement, so appearance alone does not establish interchangeability. This listing does not supply a complete door hardware set.
Common reasons to replace
- The original screw is missing after molding removal, refinishing or other door service.
- The screw head is damaged and no longer allows proper tool engagement.
- Threads are damaged, corroded or unable to engage correctly in the original receiving attachment.
- Existing hardware is an incorrect substitute and the molding cannot be secured in its original position.
Loose or misaligned molding can also result from broken clips, damaged mounting tabs or a worn receiving attachment. Inspect those components before installing a replacement screw; new hardware will not repair a cracked molding or stripped mounting point.
Vehicle fitment
Fitment depends on the original lower molding and its assigned fastening point. Confirm the complete part number against the original hardware or vehicle parts catalog before ordering.
| Vehicle | Model years | Engine | Configuration | Application restrictions |
|---|---|---|---|---|
| Audi A6 | 2008 | 3.2L gasoline V6 | C6 Sedan; original front-door lower molding; Original factory transmission configuration | Only the front-door lower molding fastening point assigned N01412216. Match the original molding and attachment; not a universal screw for door trim, belt moldings or window regulators. One screw supplied. |
| Audi A6 | 2005–2008 | 3.2L gasoline V6 | C6; quattro; original front-door lower molding | Original front-door lower molding screw, assigned position 2. Match molding and M4 × 8 fastening point; one screw supplied. Does not establish use at unrelated door or window-regulator positions. |
| Audi S6 | 2007–2008 | 5.2L gasoline V10 | C6 sedan; quattro; original front-door lower molding | Original front-door lower molding screw at position 2, either assigned side. Match original molding and M4 × 8 fastening point; one screw supplied. |
Installation and service guidance
Follow the factory removal and installation procedure for the lower door molding. Support the molding as its fastening hardware is released and protect the adjacent paint and trim surfaces from tool contact.
Inspect the molding tabs, clips and receiving attachment. Position the molding correctly before starting the screw by hand. If the screw does not engage freely, stop and check alignment and hardware identity rather than forcing it into the mounting point.
Use the correctly fitting tool and the factory tightening specification for that attachment. Do not use excessive tightening force to compensate for a broken tab or damaged receiver. After installation, check that the molding sits correctly and remains secured along its prescribed mounting points.