OVERVIEW
Specified socket-head bolt for the original battery clamp
N-014-715-10 is the Genuine VW/Audi M8x45 internal-hex bolt assigned to the battery clamping-strip arrangement on the confirmed PR 5C1 applications below. It is small mounting hardware for securing the original clamp.
Fasteners with a similar diameter can have different lengths, head forms and clamping requirements. Match the original factory number and assigned joint rather than choosing a bolt by appearance alone.
Technical details
- Complete factory number: N-014-715-10.
- Factory specification: M8 × 45 internal-hex socket-head bolt.
- Design: cylindrical socket head with partially threaded shank.
- Quantity supplied: one individual bolt.
The nominal thread and length describe the fastener itself. This listing supplies one bolt rather than the full quantity required for an assembly. Matching nuts, washers, brackets and related parts are separate.
Common reasons to replace
- The original bolt is missing after component service.
- Threads are damaged or will not engage correctly.
- The drive head is rounded or otherwise damaged.
- Corrosion or deformation makes the original fastener unsuitable for reuse.
Inspect the battery clamp, tray and receiving threads. A damaged clamp or corroded tray requires separate repair. This bolt secures the battery mechanically and is not an electrical terminal bolt.
Vehicle fitment
Use only at the assigned factory fastening position on the listed applications. These vehicle entries do not establish compatibility with every fastening point on the vehicle.
| Vehicle | Model years | Engine | Configuration | Application restrictions |
|---|---|---|---|---|
| Audi A4 | 2008 | 2.0L turbo gasoline or 3.2L gasoline V6 | B7 sedan or Avant; PR 5C1 | Original battery-clamping strip M8x45 socket-head bolt; PR 5C1 body-safety configuration required. |
| Audi S4 | 2008 | 4.2L gasoline V8 | B7 sedan or Avant; quattro; PR 5C1 | Assigned battery-clamping strip fastening position only; confirm original M8x45 hardware. |
Installation guidance
Follow the vehicle-specific battery isolation and mounting procedure. Use the correct battery size and original clamping strip, position the assembly securely and apply the prescribed bolt torque. Avoid contact between tools and battery terminals or adjacent conductive parts.
Verify that the battery cannot move in its mounting and that cables and covers are installed correctly. Complete any battery or vehicle-system reset procedure required after disconnection.
Ordering information
One individual genuine bolt. Battery, clamping strip, tray and other mounting parts are separate.