OVERVIEW
Genuine VW/Audi N-907-020-01 is an individual corrugated-tube joiner with a side opening for the original wiring-conduit arrangement assigned this part number. The confirmed Eurovan application below lists it in the central wiring assembly. It joins the matching protective conduit sections around the harness at that original location.
Technical details and what is included
- Factory part number: N-907-020-01 / N90702001.
- Component type: mechanical corrugated wiring-conduit joiner with side opening.
- Factory nominal connection designation for the confirmed wiring application: 13 × 13 × 8.5.
- Quantity supplied: one individual joiner.
- Protective conduit, wiring and other harness components are separately specified.
The factory connection designation identifies the prescribed conduit arrangement and is not a shipping or package dimension. Compare the original conduit profiles and branching layout before ordering. This mechanical conduit piece has no electrical contacts and is not a coolant-hose clamp, fluid-line fitting or complete wiring harness.
Common reasons to replace
- The original joiner body or attachment feature is broken.
- The piece no longer closes or supports the matching conduit sections correctly.
- The joiner is lost or damaged during wiring-harness service.
- Inspection identifies a damaged original conduit junction at this assigned location.
Inspect the protective conduit and wire insulation separately. Replacing the joiner does not repair a broken conductor, damaged insulation or a separately cracked conduit section. Renew any damaged components according to the diagnosed condition and factory repair procedure.
Vehicle fitment
The confirmed application requires the original corrugated wiring-conduit connection listed below. Similar conduit junctions with different diameters or branch profiles must be checked independently.
| Vehicle | Model years | Engine | Configuration | Application restrictions |
|---|---|---|---|---|
| Volkswagen Eurovan | 1997 | 2.8L gasoline VR6 | Original passenger-van body; front-wheel drive; Original factory automatic transmission; harness conduit arrangement determines fitment | Original corrugated wiring-conduit joining point assigned N90702001, factory nominal connection designation 13 × 13 × 8.5. Match the original conduit sizes and side-branch profile. One mechanical joiner supplied; conduit, wiring and other harness components are separate. Not a coolant-hose clamp or fluid-line connector. |
Installation and service guidance
Follow the factory access and wiring-routing procedure for the affected harness. Release the original conduit junction carefully without pulling on the wiring or cutting the protective conduit. Record the original branch routing and joining arrangement before removal.
Inspect the matching conduit sections and compare the replacement joiner with the original. Fit the specified conduit profiles at their assigned connections, ensuring the wiring is not trapped or pinched as the joiner is closed.
Restore the factory harness route with the prescribed clearance from moving parts and sharp edges. Verify that the conduit sections remain correctly seated and that the joined harness is free from strain. Complete any circuit checks required for the separate wiring work performed during the repair.