OVERVIEW
Factory screw for the original interior trim attachment
N-907-072-03 is the Genuine VW/Audi 4.8x16 round-head trim screw used at the assigned interior trim and handle fastening positions on the verified applications below. The exact attachment varies with the vehicle and trim arrangement.
Fasteners with a similar diameter can have different lengths, head forms and clamping requirements. Match the original factory number and assigned joint rather than choosing a bolt by appearance alone.
Technical details
- Complete factory number: N-907-072-03.
- Factory specification: 4.8 × 16 round-head trim screw.
- Design: round head with recessed drive and coarse screw thread.
- Quantity supplied: one individual screw.
This individual screw is also cataloged for deck-lid trim, handle or emergency-release trim applications. Match the original screw and receiving clip; it is not supplied with a handle, release cable, trim panel or insert nut.
Common reasons to replace
- The original bolt is missing after component service.
- Threads are damaged or will not engage correctly.
- The drive head is rounded or otherwise damaged.
- Corrosion or deformation makes the original fastener unsuitable for reuse.
Inspect the trim mounting hole and receiving clip or nut before replacement. Broken panel tabs or a damaged clip must be repaired separately; overtightening a new screw can damage the trim.
Vehicle fitment
Use only at the assigned factory fastening position on the listed applications. These vehicle entries do not establish compatibility with every fastening point on the vehicle.
| Vehicle | Model years | Engine | Configuration | Application restrictions |
|---|---|---|---|---|
| Audi A4 | 2017–2020 | 2.0L turbo gasoline | B9 sedan; front-wheel drive | Original assigned trim/handle screw position N90707203 only. |
| Audi A4 | 2017–2025 | 2.0L turbo gasoline, including applicable mild-hybrid configurations | B9 sedan; quattro | Original assigned interior trim/handle attachment; confirm trim and original screw number. |
| Audi RS3 | 2022–2025 | 2.5L turbo gasoline five-cylinder | 8Y sedan; quattro | Original assigned trim/handle screw only; not a general-purpose structural fastener. |
| Audi RS5 | 2018–2019, 2021–2024 | 2.9L twin-turbo gasoline V6 | Coupe; quattro | Original assigned trim/handle screw position only; match original N90707203. |
| Audi S3 | 2022–2025 | 2.0L turbo gasoline | 8Y sedan; quattro | Original assigned trim/handle screw only; confirm original attachment. |
Installation guidance
Use the vehicle-specific trim procedure and the correct drive tool. Align the trim and receiving clip before starting the screw, and use the prescribed tightening torque. Keep the original clip and screw positions distinct from nearby structural hardware.
Check that the trim is seated evenly and that any adjacent handle or release mechanism operates freely. Confirm that no wiring or release cable is trapped behind the trim.
Ordering information
One individual genuine bolt. Related nuts, washers, brackets and other assembly components are separate. Confirm VIN and original hardware number.