OVERVIEW
Original mounting screw for the specified frame and cover attachment
N-911-883-01 is the Genuine VW/Audi M6x20 mounting screw used at the specified original frame or cover attachment points. Its broad rounded head and threaded shank match the original fastener configuration shown in the archive photo.
A correct replacement screw preserves the intended head seating and thread engagement at its assigned mounting point. Different frame and trim locations can use different fasteners on the same vehicle, so identify the original complete number before ordering.
Technical details
- Complete factory number: N-911-883-01.
- Factory specification: M6 × 20 factory mounting screw.
- Design: broad rounded head with internal drive and threaded shank, as pictured.
- Quantity supplied: one individual mounting screw.
One individual mounting screw is supplied. Frame, cover, trim, brackets and other hardware are separate. This is replacement hardware for its original mounting position, not a general-purpose substitute for every M6 screw.
Common reasons to replace
- The drive recess or threads are damaged.
- The head is distorted and will not seat correctly.
- The original correct screw is missing.
- The applicable repair procedure calls for a new fastener.
Inspect the mating thread, bracket and seating surface. A new screw cannot repair a cracked mounting feature or stripped thread. Compare the original screw and assembly position before installation.
Vehicle fitment
Use only where the original frame or cover assembly specifies this complete fastener number. Confirm the mounting point and body equipment rather than selecting by vehicle model alone.
| Vehicle | Model years | Engine | Configuration | Application restrictions |
|---|---|---|---|---|
| Audi A3 Cabriolet | 2015–2016 | 1.8L or 2.0L turbocharged gasoline | 8V Convertible; FWD or quattro as equipped | Assigned original frame/cover mounting-screw position; confirm original N-911-883-01 number and mounting location. |
| Audi A3 Cabriolet | 2017–2019 | 2.0L turbocharged gasoline | 8V Convertible; FWD or quattro as equipped | Original frame/cover mounting position requiring this exact screw; match original part number. |
| Audi A5 | 2018–2024 | 2.0L turbocharged gasoline; MHEV where equipped | B9 Coupe or Cabriolet; quattro | Assigned original frame/cover mounting position only; match original screw number and assembly. |
| Audi R8 | 2014–2015 | 4.2L gasoline V8; 5.2L gasoline V10 | Coupe or Spyder; quattro | Original mounting position specifying this complete screw number; verify body equipment and serviced assembly. |
Installation guidance
Follow the repair procedure for the exact frame or cover being serviced. Support the component as required, start the screw by hand and tighten using the correct driver and joint-specific factory specification.
Confirm correct seating and attachment. Check the movement and clearances of any affected cover or frame using the applicable repair procedure.
Ordering information
One individual Genuine VW/Audi mounting screw. Frame, trim and other hardware are separate. Confirm original part number and mounting point.